When moving, please ensure the handle of the pinch-roller is lifted up, then hold the back of the holder and push it to the left or the right.
Cutting plotter has 2 to 4 pinch-roller assemblies (depending on machine size) and they can be moved on the guide rail. Adjust the place of pinch-roller according to paper-width. Four 1 ½ pointed screws attach to bottom of standħ V. Note: on larger stands there will be two middle bars to attach. Two ¾ inch pointed screws placed inside of the black sleeve attach to the sides of the middle bar and covered on the ends with the black grommet cover. Three 1 ¼ inch flat tip screws with matching metal connecting grommets to screw on the ends will connect the vinyl roll holder side arms. Assembly Diagram of Plotter stand Bridge PRO720 Assembly Description 1.
Cutting Width 275mm 630mm 780mm 1010mm 1260mm Cutting Speed mm/s Cutting Force g RAM LCD Display Communication Port 1M Backlit LCD Display Serial/Parallel/USB Port Power Requirements AC110V☑0% or AC220V ☑0% Repeatability Mechanical Resolution Command Set mm mm/step DMPL / HPGL Working Temperature 0-35 Condition Humidity 5%-65%(without condensation) Remark: Except for PRO365, all other models include Aluminum alloy floor standĦ IV. Always move the unit by holding from the bottomĤ II. To prevent damage to the moving track do not attempt to move the unit by lifting from the top. If you do not have 110v a voltage stabilizer should be used. Do not attempt to pull media manually through machine as this may damage the stepping motors and control unit. Locking them without media may cause damage to the rubber traction material and damage the metal bottom roller. If there is no media (vinyl, paper, etc.) in the machine do not lock down pinch rollers. Turn the power off when the machine is not in use. To ensure the machine work safely and reliably, please always connect the power cord to grounded power outlet. This may cause damage to the electrical components. Keep all magnetic sensitive and other magnetic material away from the unit. Keep your hands and hair away from the metal rollers at all times to prevent injury from moving parts and cutting blade.
Do not connect or remove serial cable/parallel cable when the unit is powered up. General Safety Rules Please read the following before operating the plotter! 1.
Getting Started with USB Port Getting Started with Parallel Portģ I. 1 Bridge Cutting Plotter PRO365/720/870/1100/1350 Instruction ManualĢ Table of contents I.
0 kommentar(er)
